Description
How And Where To Use This Foam Blocker Seal Kit?
First, You Need To Check The Accuracy Of The Installation Of The Previous Seal. One Reason A Foam Seal May Fail Is Because It’S Not In The Right Position. Take Note Of The Position Of The Old Seals Or Take A Picture Of Them Before Removing Them.
Next, Gently Scrape Off The Old Foam Patch. Be Mindful Of Thepaint So Only Use Paint-Safe Adhesive Remover Or Alcohol Wipes. Ensure That The Surface Is Dry, Free From Dirt/Dust, And Grease Before Installing The Foam Pads.
But Where To Use These Foam Pieces? Use This List As A Guide:
?4 Pieces Of Corner Patch (Two Right And Two Left) Use On The Front And Rear Outboard Corners On Both Right And Left Freedom Panel Top
?3 Pieces 30Mm X 75Mm X 3 Mm Rectangle Seals For The Rear Inboard Corner (Left And Right Panels) Interface
?1 Piece 30Mm X 75Mm X 2Mm Rectangle Seal Used On The Flame Tip Of Front Molded Detail Section Of The Center Seal
?2 Pieces 20Mm X 95 Mm X 5Mm Rectangle Seals Used On The Rear Outboard Corner (Left And Right Panels) To Hardtop Seal
?2 Pieces 30Mm X 95Mm X 3Mm Rectangle Seals For The Front Outboard Corner (Left And Right Panels) To Header Seal
?2 Pieces 9Mm X 100Mm X 6.35Mm Thin Foam Strips Used On The Left And Right Panels Of The Front Outboard Corner To Header Seal
?1 Piece 13Mm (Outer Diameter) X 8Mm (Inner Diameter) X 160Mm Windshield Header Seal Round Stuffer For Placing Inside Windshield Header Seal Bulb
Reviews
There are no reviews yet.